Many owners will find that after the tiles have been tiled, there is a certain gap between the gaps in the tiles and it is easy to accumulate ash, which affects the aesthetic appearance of the entire floor. Second, to solve this problem is very simple, we can use this to make the whole ground more beautiful appearance, the following small series for everyone to introduce the specific methods of the United States under the tile and the United States and the contents of grout material it!
How to make a beautiful tile
1. Before starting to lay tiles, pre-shop should be done first, and at the same time reserve the gap between each tile. Generally, the gap between tiles and tiles should be about 1-6mm in width. Because the gap is smaller, the overall effect of the ground will be very three-dimensional and full of layers after the jointing. Therefore, it is better to ask the professional workers for the construction of the floor tiles, and there are more techniques for controlling the width and depth of the tiles.
2, before the construction of the tile, you also need to clean the dust and debris inside the gap, you can use a vacuum cleaner to clean, so that the tile gap is dry, no dust, no debris, so that it is not prone to uneven ground or empty drum phenomenon .
3, tile the United States and the United States is the first step in the seam seam, and then do the floor tile seam, the specific approach is to use white cement first, with a professional tool to tile surface cement caulking pressure, smooth, to ensure the depth of the gap About 1mm. After caulking, you need to wait until the white cement is completely dry before you can apply it.
4, then prepare to apply glue, first wet the tiles between the gaps with water, we must pay attention to the gap needs to be kept clean and dry. Then lay a masking paper and gently squeeze the glue into the gap in the tile. After the construction is completed, it is then smoothed. When the glue is not completely dried, tear off the masking paper.
5. Finally, after the glue is dried, remove the excess glue and scrub it with a sponge.
What kind of material is good for US grout?
1, white cement
The surface of white cement is bright and white with bright color. It is mainly divided into ordinary white cement and decorative white cement. It is used to crack the gap of white tiles.
Advantages: cheap, white surface.
Disadvantages: low strength, chalking phenomenon is more serious, brick seams are easy to change color.
2, sealant
Sealant is also called seam sealant. It is a kind of material commonly used for tile jointing, and it is made of white cement as the main material, and it is a dry powder material that is mixed with certain inorganic dyes. The surface whiteness is about 86%, and the strength is higher than that of white cement.
Advantages: The sealant has strong adhesion, pressure resistance, wear resistance, easy operation, and can prevent cracks.
Disadvantages: The surface is dirty and does not have waterproof properties.
3, US grout
US Gum is a new type of organic material. The whiteness of white is even higher than that of grout. The surface is bright and clean.
Advantages: colorful, high gloss, waterproof, not dirty, better performance than sealant.
Disadvantages: low hardness, thin protective layer, obvious collapse after curing.
Xiaobian Summary: US ceramic tile joints how to do, the US joint agent what material a good introduction to this content, we want to help! When the tiles are beautifully stitched , follow certain steps. It is recommended that you refer to the detailed steps above.
Grease GUN
SUZHOU CREATION SPACE INTELLIGENT TECHNOLOGY CO.,LTD , https://www.mypkey.com