[Asia pump network] vacuum pump maintenance and repair methods: vacuum pump exhaust smoke; vacuum pump fuel injection, oil spills; vacuum pump noise exceeded; vacuum drop; Vacuum pump maintenance and repair If the vacuum pump is not a serious problem, you can open the vacuum pump, replace the vacuum pump consumables after the vacuum pump cleaning assembly to achieve the purpose of maintenance vacuum pump. The right maintenance of the vacuum pump can reduce the difficulty of the maintenance of the vacuum pump should be properly maintained on the vacuum pump to better use the vacuum pump, the following questions on the maintenance of the vacuum pump recommendations: 1, the first installation of the vacuum pump should check whether the motor is forward, that is Motor and pump rotor to the same direction, the general motor above the motor marked the normal direction of operation. Vacuum pump should be installed in a clean, clean environment, should not have debris, dust, water, the temperature is too high. 2, if the vacuum pump inhaled impurities, dust, water, chemicals and other potential hazards, should be installed in the vacuum pump inlet precision filter, if the impurities, dust, water is too large, you must install a piggy bank for filtration, To prevent dust and water chemicals and other impurities into the vacuum pump. 3, the normal operation of the vacuum pump, pump vacuum pump should be maintained at not less than the oil line, refueling, prohibited with different grades, models of vacuum pump oil mixed use. 4, After using the vacuum pump, the vacuum pump should be put, a long time down Before starting the vacuum pump, vacuum pump should be started intermittently 5, vacuum pump oil should be replaced on a regular basis, usually 3 to 6 months to conduct a replacement, such as pump oil emulsion found , Carbonation, etc., but also for the timely replacement of vacuum pump oil. If the vacuum pump needs 24 hours to operate, the vacuum pump must be serviced every six months. (Editor: Xiaoxia QQ:) Recommended reading: 2017 exhibition information
Replacement PWP Screens for Derrick 313 Shakers
SJ-Derrick 313 PWP Shaker Screen is designed for the replacement screen of Derrick 313M shale shaker. There is an operating handle on one side of the screen and a triangle breach in the center of the opposite side. Thanks to he machine assembled backside seal rubber, even the strip appears a small broken part, the other parts will be steady on back panel still. The most obvious advantage of PWP screen is better resistant to oil. And mesh sizes are commonly available from API 40 to API 270.
Technical Parameter
-
Material: stainless steel 304/316/316 L.
-
Construction Type: PWP (perforated wear plate).
-
Wear Mesh Shape: rectangle.
-
API RP 13 C Designation: API 20 – API 325.
-
Series: DX, DF, HP optional.
-
Color: green.
-
Package: 2 pcs per carton, 20 pcs/wooden case.
Adaptable Shale Shaker Model
SJ- Derrick 313 PWP shaker screen are used as the substitute screen for
-
Derrick 313 4-panel shaker.
-
Derrick Triple 313 shaker.
Remarks:
Derrick 313, PWP, DX, DF, HP are marks of Derrick Corporation.
ShengJia only produces the replacement screens but not original from Derrick.
Derrick 313 Pwp Shaker Screen
Derrick 313 Pwp Shaker Screen,Derrick 313 Shaker Screen,Derrick 313 Shale Shaker Screen ,Derrick 313 Pwp Shaker Screen
Anping Shengjia Hardware Mesh Co.,ltd , http://www.oilshakerscreen.com