The smooth timing protection of the bearing can maximize the service life of the bearing

Home>Bearing knowledge> Timing smooth protection of bearings can be used for the highest bearing life
/*728*90 created on 2018/5/16*/ var cpro_id = "u3440131";

The smooth timing protection of the bearing can maximize the service life of the bearing

Source: Bearing network time: 2013-11-20

/*250*250 was created on 2017/12/25*/ var cpro_id = 'u3171089';
Proper smoothness and protection can promote the highest service life of the bearing.
The smoothest smooth smooth bearing is the best time to stop the equipment in the program; and make up for it at regular intervals; together; remove the old grease or squeeze out the old grease through the drain. The nozzle is clean and clean. If the bearing housing does not have a grease fitting; the bearing housing cover or end cover should be opened; in order to remove the old grease; after finishing; make up the same type of fresh grease.
Smooth oil smooth timing to check the oil level and oil quality of the smooth oil; normally; the normal oil level should be within the range of 1/3-2/3 of the equipment oil level window. The oil filling method is the oil cup; The oil level only represents the oil replenishment; the bearing tank oil level is satisfactory for the operation; the oil level in the oil cup is less than 1/4 of its total volume.
View and replenish the oil method; take out a small amount of smooth oil as a sample and compare it with fresh smooth oil; the qualified unit can think about the oil quality test; to ensure the oil quality is qualified. If the sample looks like a cloud; then it can be with water The result of the mixing; that is, the oil emulsification we often say; the smooth oil should be replaced at the moment. If the sample is darkened or thickened, it can be shown that the smooth oil is now carbonized; the old smooth oil should be completely replaced. If it is possible; use fresh smooth oil to wash the oil circuit. When replacing the smooth oil; should ensure that the replacement of the smooth oil is the same as the new and old type; and make up for the satisfactory oil level.
Use oil-type smooth system; if the oil temperature is below 60 ° C (140 ° F); and the smooth oil is not contaminated; then replace the smooth oil once a year. If the oil temperature is 60-100 ° C (140- 210°F); replace the smooth oil four times a year. If the oil temperature is 100-120°C (210-250°F), replace the smooth oil once a month. If the oil temperature is 120°C (250°F) Above; then replace the smooth oil once a week.
The correct device and protection are important factors for the normal operation of the bearing; together; it is necessary to pay attention to the cleanliness of the bearing. It is necessary for the bearing to avoid contamination by pollutants and moisture; it is necessary to have the correct device and smooth. The description of the bearing arrangement, the condition of the oil seal, the way of the smoothing agent and the replacement cycle and the special protection play an important role; it is necessary to pay attention to it.

Recommend to friends comments close window

Bearing related knowledge
Analysis of the skills of the launching machine sliding bearing (1)
Bearings need to pay attention to five major issues in the work of rolling bearings, the increase in the amount of grease, the selection of low-noise bearings, the concept and terminology of the installation of small-diameter rolling bearings


This article links to http://
Please indicate China Bearing Network http://

Previous:The demand for SKF bearings for machine tool spindles Next:Select the six elements suitable for rolling bearing type

Safety Vent Valve

ZHEJIANG HESHUO TECHNOLOGY CO.,LTD , https://www.hosuocn.com

This entry was posted in on