The design of the reducer sensor is designed to ensure that the workpiece surface has a uniform uniform layer distribution, high electrical efficiency, sufficient mechanical strength, easy installation and adjustment, and convenient operation. The intermediate frequency quenching sensor along the tooth groove is mainly composed of a flange plate, a connecting plate, a toothed portion and a magnetizer. One is a linear motion of the sensor along the tooth groove; the other is the linear motion of the sensor along the tooth groove, because the speed reducer The height of the inductor remains the same, and the gear shaft is helical, so the gear shaft must be swiveled by the angle of the helix.
If the gas accumulates at the top of the pump, the gas of the reducer gradually increases, so that the oil surface of the pump is at the upper part of the piston port, and the pump power is affected, so that the pressure-building efficiency of the oil pump is reduced, causing the oil pump to run for a long time or frequently pressing to ensure that the sensor enters. Before the tooth groove, the guide bar has started to guide, and the guide bar continues to guide a certain distance before the sensor leaves the workpiece; the guide bar can be adjusted in a certain range in height, front, back, left and right, so that the guide is smooth.
The mechanical device of the reducer utilizes a mechanical combination of a float ball and a lever to be simple and reliable. The device's air tightness was tested in 2 times the actual differential pressure.
According to the tooth shape, the two-headed sensor head is made of a square copper tube, so that the gap between the outer surface of the reducer head and the tooth surface is 2 mm. Through the feedback on the actual application of the process device, the circuit breaker with the device installed has no frequent pressing defects, and the staged verification has achieved the expected effect.
There are three types of Dip switch led batten lights, Change CCT Light, Change Power Light, and Change CCT and Power light.
In other words, this batten light can change the color temperature and power. It is mainly possible to change the color temperature and power by turning the DIP controller inside the lamp body. Moreover, you only need to press the button on the side of the light to open the light body, which is very easy to operate.
The function of changing color temperature and power is very suitable for stock. Before shipping, you can set the color temperature and power that your customers want.
The adjustable range of color temperature is: 3000k/4000k/5000k, 4000k/5000k/6000k.
The power adjustment range is: 5 /10 /15 /20, 5 /15 /25 /30, 10 /20 /30 /40, 10 /25 /40 /50, 10 /25 /40 /50, 20 /30 / 50/60.
This batten light is suitable for warehouses, shops, corridors, offices, factories, and other indoor places.
Shop Led Light Fixtures,Workshop Led Light,Shop Light Fittings
SHENZHEN LITEHOME OPTOELECTRONIC TECHNOLOGY CO., LTD. , https://www.litehomelight.com