A lot of people will find it when they finish the renovation. This is not right nor right, the kitchen is one of the key areas in the decoration, but also the most prone to problems, Xiao Bian today to give you a summary of the most likely misunderstanding of the kitchen decoration!
First, only to buy the cabinet after the renovation
Because the installation of kitchen cabinets and kitchen decoration is one, the kitchen is different from the living room and other places. Do not purchase cabinets for installation after renovation. The correct method is: before the renovation, please cabinet manufacturers to measure, set the cabinet style model, set aside the pipeline interface and the corresponding space, and then carry out renovations, and finally the cabinet manufacturers to enter the construction.
Second, is your home really suitable for open kitchens?
If you are a Chinese food lover who likes to do it yourself, and ignore the shortcomings of the open kitchen, it is a problem. Just think, if the room is full of greasy and spicy, I am afraid that "enjoy" is not just the fun of eating. For these friends, it is recommended to use a compromise method, high-power range hoods and glass partitions. Both transparent effects, but also eliminate the fumes of soot.
Third, the only pursuit of good-looking and non-slip tiles
People who have this idea probably won't clean the kitchen themselves. If the tile with uneven surface does not wash frequently, the grease will adhere to the gaps and pores and be difficult to remove, which will affect the cleanliness and beauty of the kitchen. Therefore, in the selection of such as ceramic tile, aluminum buckle ceiling, art design, should be flat, smooth surface is better.
Fourth, the range hood closer to the stove as possible
In order to enhance the function of range hoods, many people think that the hood is as close to the stove as possible. In fact, the effective distance of the range hood is usually 80 cm, and the smoking effect is almost the same in this range. Therefore, the range hood can be installed on the basis of the height of the owner. The height of the hood is usually about 80 cm and should not be too high or too low.
Fifth, choose the cabinet panel, ignore the inherent quality
When choosing panels, people often only pay attention to their appearance and surface properties. They only look at whether the outer surface is waterproof, fireproof, and scratch-free, but they neglect the inner “heart†quality. The most direct way to discern the sheet density is to ask the sales person to take out the panel model and observe whether the cross-section particles are tight. High quality cabinetry panels are the hallmark of high quality cabinetry.
Sixth, the more cabinets, the more useful
Some people fear that the storage space in the kitchen will be insufficient. Therefore, they prefer to choose cabinets with more cabinets. The choice of cabinets does not lie in how much better, but should be reasonable and effective. Too many cabinets not only take up part of the activity area, but also make the kitchen appear to be heavily depressed. The number of cabinets should be based on the actual situation in your home.Seventh, hardware accessories don't pay much money
In all kinds of furniture, cabinets should be regarded as the most frequently used. The quality of hardware accessories directly determines the quality and service life of the cabinet. Therefore, when customizing cabinets, it is not desirable to use poor quality products in order to save money. When choosing a cabinet, you may wish to first look at the hardware brands it uses. If economic conditions permit, you can use higher-priced high-end hardware products. The quality of hardware is very important for the service life of the cabinet.
Eighth, single lighting source
I believe you have had this kind of trick: When you wash rice away from the ceiling light, even if you grow big, it will inevitably cause some bad rice to be missed. Sometimes, the chopping board will just cover your shadow and chop the vegetables. Had to go with the feeling. Today, this kind of "power-saving eye" lighting has become obsolete! Modern kitchen lighting design is divided into two levels, in addition to the lighting of the entire kitchen, in the washing area and operating table also need to add a special cabinet lamp. This type of shooting light is moderate, easy to switch, and frees your eyes.
Ninth, do your best to accommodate
Sometimes young people, for the sake of simple, avant-garde style, can do their best to house the cabinets and “hide†all their brains. In fact, simplicity is not equal to nothing. The use of stainless steel pendants and partitions are organized in an orderly manner, which not only allows you to operate with ease, but also adds a breath of life. Why not go for it? Suitable kitchen accessories will facilitate your actual use.
Tenth, kitchen cabinets, cabinets are used to open the door
In order to pursue formalization of cabinets or reduce costs, some people use the form of two-doors for cabinets and cabinets, but this will cause inconvenience to users. If the cabinet door is opened on the side, the operator should pick up the items in the operating area next to it. If he does not pay attention, the head will hit the door. The items stored in the bottom of the cabinet must be squatted to get them.
Tips: More practical decoration knowledge, real scene with the shoot, please pay attention to the palm of this site (micro signal: mall_jia).
Kitchen kitchen decoration
Engineering Veneer is a thin sheet of wood, rotary cut, sliced or sawed from expensive natural wood. The Veneer is easy to be edge jointed and overlaid on Plywood , MDF, particleboard and so on. So, it can be used in fancy plywood, fancy MDF, fancy Blockboard and veneer faced Particle Board.We have Natural Engineering Veneer and Engineering Fancy Veneer
Luli Group Co., Ltd, also supply engineered wood veneers with good quality and competitive pricing.
Advantages of using veneers:
Compared to wood, one of the primary advantages of using veneer is stability. While solid wood can be prone to warping and splitting, because veneer is made of thin layers of wood glued together, the chances of splitting or cracking are reduced. Further, the glue used provides additional strength, making the end result stronger than natural wood.
Usages of Veneer:
Used to cover the surface of plywood, MDF, chipboard, blockboard and so on.
Specification details:
Sizes: 1220mm x 2440mm, 1250mm x 2500mm or as your request
Thickness: From 0.15mm to 0.6mm or as per request
Species: Okoume, Bintangor, Terminalia, Red hardwood, etc.
Grade available: A/A, A/B, B/B
Cutting way: Rotary cutting
Engineering Veneer
Engineering Veneer,Natural Engineering Veneer,Engineering Fancy Veneer,Engineered Wood Veneer
Luli Group Co.,Ltd. , https://www.plywoods.nl