FAG linear bearing assembly considerations

FAG bearings are very precise parts, and they are also high-performance mechanical transmission parts. If you do not know how to install and use the bearing during use, not only can you not achieve the desired performance results, but also it is easy to damage the FAG bearings. Then the bearings are in use. Which of these aspects need attention? The following describes the bearing installation method :
When using the installation, it is necessary to carefully and carefully do not allow strong stamping. The motor bearing has a bad phenomenon. The solution does not allow hammers to strike the bearing directly, and it is not allowed to transmit pressure through the rolling elements.
Use appropriate and accurate installation tools to use special tools as much as possible, and try to avoid the use of cloth and staple fibers and the like.
Clean motor bearings that try to keep FAG bearings and their surroundings generally use sodium-based grease. Even if the invisible dust is invisible to the naked eye, it will increase wear, vibration, and noise.
Prevent Corrosion of FAG Bearings When the bearing is directly taken by hand, thoroughly wash away the sweat from the hands and apply a high-quality mineral oil before performing the operation. In the rainy season and summer, in particular, pay attention to rust prevention. Under certain special operating conditions, bearings can achieve longer life than traditional calculations, especially at light loads. The analysis of the mechanism and influencing factors of the labyrinth seal of the bearing housing These special operating conditions are when the rolling surfaces (tracks and rolling elements) are effectively separated by a lubricant film and limit the surface damage that may result from contaminants. First of all, when the linear bearing is installed, please try to rotate the shaft with a FAG bearing assembly by hand and observe the following conditions of the linear bearing:
1. Whether the rotating system collides with or interferes with the fixed parts,
2. The rotation of the rotating system is a stable and flexible axe, no loosening, or back and forth turbulence;
3. Is the end face of the inner ring of the linear bearing firmly in contact with the end face of the shaft shoulder, and is there any gap in the gap between them?
4. Observe whether the supply or circulation of lubricating oil is normal, whether the clearance of the sealing device is symmetrical and whether the fasteners are loose.
Secondly. Also check the rotation accuracy, axial limit accuracy, working clearance, and other necessary inspection items of the linear bearing rotation system.
Later, when the above inspection items are confirmed to be all normal, they can be used, but if any abnormal signs are found, they should be immediately stopped and troubleshooting.