Common bearing wear and its countermeasures

Source: China Bearing Network Time: 2014-06-22

/*250*250 was created on 2017/12/25*/ var cpro_id = 'u3171089';

Usually; if the bearing is used correctly; can be used until the end of the fatigue life is stopped. But there will be accidental premature injury; the condition that is not used. This early damage; relative to the fatigue life; is called fault or incident The quality of the application of the limit. Due to the inconvenience of the device, the application, the lubrication; the foreign matter invading from the outside; the research on the thermal influence of the shaft and the outer casing is not sufficient.
The damage condition of the bearing is as follows: the ferrule of the roller bearing and the shank of the rib; the reason can be considered; the lack of lubricant, the unsuitability, the disadvantage of the oil supply structure, the intrusion of foreign matter, the bearing device error, the shaft deflection The song is too big; there will be coincidences.
Therefore; only the bearing damage is inquired; it is difficult to know the true cause of the damage. However, if the bearing is used, the operating conditions, the structure around the bearing, and the condition before and after the attack are known; the damage condition of the bearing and several causes are investigated. Can avoid similar attacks.

Recommend to friends comments close window

Bearing related knowledge

INA bearing will attack the three conditions of the noise analysis of the rolling bearing installation process concept and terminology commonly used bearing distinction method "cone hole rolling bearing disassembly principle" is what the store bearing varieties at the time

This article links to http://
Please indicate the bearing network http://

Previous:Analysis of the relationship between the material and function of the bearing Next:Analyzing the application data of SKF bearing

Glass Sliding Door

Products characters

1.All the products produced by good quality building material factory need get through three strict inspections before packing: Raw material cutting test, Production process inspection, The finished debugging.

2.Providing customized service to apply each customer requirements, we will try our best to achieve 100% customer satisfaction.

Profile

1.High quality aluminum alloy profiles, thickness 1.2-2.0mm

2.Excellent quality thermal break aluminum profiles, thickness 1.4-3.0mm

3.PVC/UPVC material (need to be ordered)

Color

White/ Sliver / Grey / Champagne / Black / Wood grain / special color can be ordered

Glass Type

1.Single toughened glazing:6mm/8mm/10mm/12mm...

2.Double toughened glazing:5+12A+5mm/6+12A+6mm...

3.Laminated glazing:5+0.38PVB+5mm/6+0.76PVB+6mm...

4.Low-E glazing:Green/Blue/Brown/Golden...

5.Other glazing:frosted glass/crystal glass/art glass...

Mesh

1.Aluminum security mesh

2.Stainless steel security mesh

3.Solid iron security mesh

4.Mosquito net(Nylon,Stainless steel,Diamond)

Hardware

1.Germany brand

2.Japanese brand

3.Chinese top brand

Surface treatment

1.Anodizing

2.Powder coating

3.Electrophoresis

4.Fluorocarbon paint

Glass Sliding Door,Tempered Glass Sliding Door,Double Glass Sliding Door,Automatic Glass Sliding Door

Shenzhen Hongfa Automatic Door Co., Ltd. , https://www.hfrollershutterdoor.com