Initial treatment of the bamboo surface. The surface is yellowed, that is, the bamboo and bamboo are removed, leaving only the middle part of the coarse fiber. Zhuqing is also known for its partial densities and coarse fibers, and it has a different shrinkage deformation rate under the same humidity conditions, so it is prone to cracking. Bamboo yellow is also the bamboo part of the inner wall of the bamboo tube. The nutrients such as sugar are high, and it will be easy to mold.
Process: Due to its higher bending strength than wood, the 17mm thick bamboo flooring has sufficient bending, compressive and impact strength in the thickness, and the foot feel is also good. Some manufacturers to cater to consumers, the thicker the better the state of mind, do not go green, do not go yellow, bamboo glue, although the thickness of bamboo flooring up to 18mm, but the bonding strength is not good, but easy to crack. The quality of the bamboo flooring is the bamboo strips on both sides of bamboo green, bamboo yellow coarse planing, in order to make the bamboo slab glue tight, but also to its fine planing, thickness and width tolerances should be controlled at 0.1mm Inside.
Identification: shagreen to yellow is not completely bamboo can not be done side pressure plate, so focus on looking at the pressure plate, flat plate is a three-tier structure, cheap floor, surface layer are used good bamboo, and the middle layer and back There is a shoddy phenomenon on the board. Turn the floor over and check if there is any bamboo.
Process: Due to its higher bending strength than wood, the 17mm thick bamboo flooring has sufficient bending, compressive and impact strength in the thickness, and the foot feel is also good. Some manufacturers to cater to consumers, the thicker the better the state of mind, do not go green, do not go yellow, bamboo glue, although the thickness of bamboo flooring up to 18mm, but the bonding strength is not good, but easy to crack. The quality of the bamboo flooring is the bamboo strips on both sides of bamboo green, bamboo yellow coarse planing, in order to make the bamboo slab glue tight, but also to its fine planing, thickness and width tolerances should be controlled at 0.1mm Inside.
Identification: shagreen to yellow is not completely bamboo can not be done side pressure plate, so focus on looking at the pressure plate, flat plate is a three-tier structure, cheap floor, surface layer are used good bamboo, and the middle layer and back There is a shoddy phenomenon on the board. Turn the floor over and check if there is any bamboo.
Brass knurled thread insert Made of material, good thermal conductivity and heat resistance.
Widely Used On the Injection molding for Tightly Fixing.
Can be installed by ultrasonic or heat into thread tapered hole, or molded in during injection.
China leading manufacturers and suppliers of Hex Nut,Hexagonal Nut, and we are specialize in Stainless Steel Nuts,Hex Nut Bolt, etc.
Brass hex nut,hex coupling nut,hex flange nut,hex thin nut,hex bolts and nut
Shenzhen Lanejoy Technology Co.,LTD , https://www.copper-nut.com